Sansui Au-D607G Extra pastiprinātājs ar lielisku iebūvēto Mm/mc fonokorektoru. Pastiprinātājam veikta pilna profilakse. Paredzēts Japānas tirgum 100V , transformātors 220V komplektā.

Specifikācija:
Effective power 90W + 90W (8 ohm, 10 hz to 20 khz, THD 0.003%)
90W + 90W (8 ohm, 1 khz, 0.002% THD)
Total harmonic distortion factor (10 Hz to 20 kHz at effective output) 0.003% or Less (8 Ω)
Intermodulation Distortion Factor (60 Hz : 7 kHz = 4 : 1, SMPTE) 0.003% or Less (8 Ω)
Output Bandwidth (IHF, both channel operation, THD 0.02%) 5 Hz ~ 70 kHz (8 Ω)
Damping factor (new IHF, 20 Hz to 20 kHz) 100 (8 Ω)
Frequency Response (1W) DC ~ 300 khz + 0 -3dB
Envelope distortion Below the measurement limit
TIM Strain (Sawtooth method) Below the measurement limit
Slew rate 180 v / μ sec (8 Ω)
Rise time 0.8 μ sec
<Equalizer amplifier (Hi-Precision DC servo equalizer)>
Input Sensitivity / Input Impedance (1 kHz) Phono1, 2 mm : 2.5mV/47k Ω
Phono1, 2 mc : 120 μ V/3 ~ 40 Ω
Tuner, Aux/DA, Tape/PCM play1, 2 : 250mV/27k Ω
Phono maximum allowable input (1 kHz, THD 0.01%) MM:200mV
MC : 10 mv, TRANS system
Output Level / Impedance (1 kHz) Tape rec (PIN) : 250 mv (47k Ω) / 600 Ω
Total harmonic distortion factor (20 Hz to 20 kHz at 5 V output) Phono1, 2 MM : not more than 0.005%
Phono1, 2 mc : TRANS system
RIAA Deviation (MM, Rec out) 20 Hz to 300 kHz 0.2 dB
Signal-to-noise ratio (A network, short circuit) Phono1, 2 mm : 88 dB or more
Phono1, 2 mc : 79 dB or more (120 μ V)
Tuner, Aux/DA, Tape/PCM play1, 2 : 110 dB or more
Phono input equivalent noise
(A network, short circuit) Phono1, 2 mm : -140dBV
Phono1, 2 mc : -157dBV
Channel Separation (1 kHz) Phono1, 2 mm : 60 dB or more
Phono1, 2 mc : 50 dB or more
Tuner, Aux/DA, Tape/PCM play : 80 dB or more
Tone control Bass : 6 dB (50 Hz)
Treble : 6 dB at 10 kHz
Filter Low : 16 Hz (-3dB, 6dB/oct. )
Audio Muting -20dB
<General>
Rated power consumption (Electrical Appliance and Material Control Law) 220W
External dimensions Width 460x Height 160x Depth 404 mm
Weight 13.5kg